Pump
Maintenance Program
Includes Pump Service to N.F.P.A. 1911 Standards |
| |
Fluids |
- Drain
and replace oil in pump transmission
- Check
radiator, cooling valve and plumbing
- Check
and fill primer reservoirs as needed
|
|
Lubricate
and Inspect |
- Ball Valves
- Control
Linkage
- Volume Pump
- Primer Linkage
- Relief Valve
Pilot
- Transfer
Valve
|
|
Inspect |
- Primer Device
- Pump Shift
- Pump Packing
- All Gauges
- Tachometer
- Hose reel
drive, Alignment and Swivel
- Electrical
System and Light (Pump Operation)
- Master Drains
- Panel Counter
- Discharge
Valves
- Intake Valves
|
|
Testing |
|
- Volume Pump
Relief Valve
- Pump Dry
Vacuum Test
- Transfer
Valve
|
|
Note: Any
defective items found will be noted on a complete written
report, this will include a cost estimate for parts
and labor. All components must be in safe working condition
prior to pump test.
Pump
service tests will be done after maintenance has been
completed. |
|
|
|
Rennert's
Fire Equipment Full Chassis P.M. Program |
|
Engine |
-
Change engine
oil
-
Change oil
filters
-
Change fuel
filters
-
Change water
filter
|
|
Full
Chassis Lube |
|
Checks |
- Transmission
oil level
- Rear end
oil level
- Tire air
pressure
- Brakes
- Batteries
- Charging
system
- Steering
and related components
|
*Oil
and filters can be supplied by dept. or by Rennert's
Fire Equipment |
|
*For
transmission oil and filters
Standard
M.T. 600 Series Auto
World Transmission |
|
Additional
Checks Done |
- Review units
history
- Record
RPM high & low
- Ck operation
of all lights
- Ck dash & upholstery
screws
- Ck any wiring
done by dept.
- Manual shift
boot
- Radiator
cap
- Cab bushings & bolts
- Alternator
brackets & belts
- All belts
for cond. & adj.
- Leads
to starter & ground
- Crossmember
bolts
- Drive shaft
sliders
- Breather
caps
- Engine & transmission
mounts
- Battery
water level & clean terminals
- Record clutch
free travel
- Ck gauges & interior
lights
- Ck operation
of wipers
- Ck windshield
for cracks
- Air pressure
loss (brake pedal depressed)
- Engine oil
level before draining
- Cab hold
down latches
- Exhaust
system for leaks
- Engine for
oil leaks
- Routing & cond.
of hoses
- Lube brake
cams & adj.
- U joints
- Leaf springs & hangers
- Wheelhubs
for leaking
- Tie rod
ends, steering arm, shaft splines
|
Rennert's
Fire Equipment Foam Pump Maintenance |
Checklist varies depending on pump being tested. |
-
Check water flow calibration, recal if needed
-
Change oil in foam pump
-
Check foam pump calibration, recal if needed
-
Check and clean foam screen
-
Change hydraulic oil and filter. (This will only be done at department request)
-
Reset maintenance request on display
|
|
